0 votes
463 views
I am modelling an industrial process and now I get negative values for certain steps... I am using Ecoinvent v3.9 and OpenLCA v1.11.0. For the LCIA I used ecoinvent-CML v4.8 2016. When I just run the calculation everything is fine and all numbers are positive, but if I want to know the contribution of each substep, I get some negative values. For example: for the CO2-eq: step 12: 74.6325 and for step 13: 73:6858. So if I want to know the share of step 13, logically I do Step 13 - Step 12 = 73:6858 - 74.6325 = -0.9467. This can't be right since these are consecutive steps in an industrial process and chemicals like ethyl acetate and liquid nitrogen are used but not recovered.

Is this even possible to have negative values for this?

Thanks in advance for your answer.

Greetings,
Eline

EDIT:

These are the results I get when following the advice of Sjamil. However, when calculating with the "Project" option, I get the exact same numbers. This is a problem because into step 10 go Step 6 and Step 9 (screenshots also added below) and as you can see, step 10 - step 6 - step 9 = less than zero. (In the original question I spoke of step 12 and step 13 and I also still have the same problem there.

Screenshots of step 10:

Screenshots of step 9:

Screenshots of step 6:
in openLCA by (310 points)
edited by
by (520 points)
Hello Eline, I have been thinking about your question and I found a similar issue during my analysis where the sum of % contribution is more than 100% and so on.

It appears that using the direct calculation method - my recommendation is to analyze the results from the "Contribution Tree" tab instead of the "Process Results" tab. Reason: The 'Impact Assessment Results' section in the "Process Results" tab shows the total contributions for input process flows and background process flows altogether. While the "Contribution Tree" tab displays the contributions in a top-down hierarchy. Hope this helps. Thanks
by (310 points)
Right, so I think I did as you suggested (I openend up the "product system" I made for step 10 and then calculated using the green triangle on the left above the "navigation" tab). But I still get the same results.
It appears I can't put screenshots in this comment, so I'll put in in the original question. Maybe I misunderstood your suggestion. If so please correct me because I really want to figure this out :-)

1 Answer

0 votes
by (520 points)
Hello Eline, this is very interesting. I am not sure what the solution is, though can you mention if the value 74.6325 represents the CO2 emissions? That seems like a huge number. Thanks
by (310 points)
Really? I know how to export to excel but how do you further calculate yourself that way?
...