Project and parameter sets

Question

Hello,

Working whith openLCA 2.6.0, I have created a product system with multiple parameter sets and would like to compare results of that product system with 2 different parameter sets.

So I created a project, with 2 times my product system. But I cannot find where to select the parameter sets in my project.

Thanks in advance,

Jocelyn

Answer 1

Hi :)
I am assuming you are looking for the following (see picture).

1) In your project you add the same product system twice (where the global parameter is set as an input value for some of the processes inside the product system)

2) you add the parameter and give it values depending on the scenario you want.

I hope this helps?

Cheers,

Paul

Comments

Edit: Somehow i cannot upload the picture as i get an error "Your message can contain only max 12000 characters"

So when you scroll down in the project, 1) is the green + at the section "compared product systems" and 2) is the green + next to "Parameters"

---

Hello Paul,
Thank you for your answer!
This is for setting a single parameter (or several) within a project.
What I am after is a bit different. I would like to assign parameter sets (which is a product system attribute, under product system "parameters" tab) within a project.
Best regards,
Jocelyn

---

Oh - in that case I am sorry - that i do not know ;)